Configuring The Ipmi From The Netbackup Appliance Shell Menu - VERITAS NetBackup 5230 Hardware Installation Manual

Configuring the IPMI from the NetBackup
Appliance Shell Menu

Configuring the IPMI from the NetBackup Appliance Shell Menu

Number
4
5
6
7
8
9
10
Check the power supply module LEDs on the rear panel. Each module has
■
one LED.
This section explains how to configure IPMI from the NetBackup Appliance Shell
Menu.
Before starting the IPMI configuration, obtain the following information for the
appliance for which you want to configure the IPMI:
IP address IP address for the remote management port so that the default static IP
address of the remote management port can be changed.
Subnet mask Enable connectivity between your network computer and the remote
management port.
Gateway IP Enable connectivity between your network computer and the remote
address management port.
Verifying hardware operation and configuring IPMI
LED description
Cold reset button (instantly restarts the appliance)
NIC4/eth3 activity
NIC3/eth2 activity
NMI button (This button triggers a non-maskable interrupt. All server
data is lost.)
NIC1/eth0 activity
NIC2/eth1 activity
Status
42