VERITAS NetBackup 5330 Installation Manual page 7

The NetBackup 5330 compute node contains eight disk drives. Slots 0 through 5
contain mirrored volumes for the operating system and system logs, and two
hot-spares. Slots 6 and 7 are currently unconfigured and reserved for future use.
Slots 8 through 11 contain blank carriers to maintain airflow.
The rear panel of the compute node contains embedded ports and PCIe card slots.
The embedded ports include the following (with numbers associating the ports to
the items in the bulleted list):
Four 1Gb Ethernet ports (Item 1)
■
One Video Graphics Array (VGA) port (Item 2)
■
One serial port (for Veritas Technical Support use only) (Item 3)
■
Three USB ports (Item 4)
■
One Intelligent Platform Management Interface (IPMI) port for remote
■
management (Item 5)
Two 10Gb Ethernet ports (Item 6)
■
Two power supply modules are installed in the lower left corner of the rear panel.
One of the power supplies must be operational at all times. Turn off the device if
both power supplies do not work properly.
Input power for the compute node can be 120VAC or 220VAC.
You can deploy a NetBackup 5330 high availability (HA) configuration through either
of the following methods:
New deployment for an HA configuration
■
Converting existing systems to an HA configuration
■
See "Hardware installation scenarios for a NetBackup 5330 high availability
configuration" on page 86.
For the detailed information about HA configuration, refer to NetBackup Appliance
High Availability Reference Guide.
NetBackup 5330 compute node overview
Hardware overview 7