VERITAS NetBackup 5330 Installation Manual page 45

Installing disk drives into a primary shelf or an expansion shelf
3
Starting with the bottom drawer (5), use your thumbs to pull out the two orange
latches towards the sides of the rack. Then, grasp the latches and pull out the
drawer until you can see all of the disk slots. Do not pull the drawer out further.
The front of each drawer identifies the disk drive slot numbering inside the
drawer. The numbering is the same in all drawers, as follows:
4
Take a disk drive from a box and remove its protective sleeve.
5
Pull up the disk latch and use it as a handle to install the disk into disk space
number 1 as follows:
Insert the disk straight down into the slot.
■
Align the two raised buttons on each side of the disk with matching gaps
■
in the slot.
Hardware installation procedures 45