Performing The Initial Configuration On A Netbackup 5330 Appliance From The Netbackup Appliance Shell Menu - VERITAS NetBackup 5330 Configuration Manual

Performing the initial configuration on a NetBackup 5330 appliance from the NetBackup Appliance Shell Menu

Performing the initial configuration on a
NetBackup 5330 appliance from the NetBackup
Appliance Shell Menu
Log on to the NetBackup Appliance Shell Menu and enter the
■
> Support > Maintenance
At the password prompt, enter the default
■
( ).
P@ssw0rd
At the
■ Maintenance
the password.
Type to return to the NetBackup Appliance Shell Menu.
■ Exit
For complete information about using the
see the NetBackup Appliance Commands Reference Guide.
18
After all appliances are configured and operational, you are ready to install
client software on the computers that you want to back up.
See "Downloading NetBackup client packages to a client from a NetBackup
Appliance" on page 56.
See "Installing NetBackup client software through CIFS and NFS shares"
on page 60.
This topic describes how to configure a NetBackup 5330 appliance that is new or
has been reset to the factory defaults (factory reset).
This method requires that you connect a laptop directly to appliance port NIC1
(eth0). A NetBackup 5330 appliance can only be configured as a media server.
Before you perform the initial configuration on this media server, verify that you
have already performed the following tasks:
Verified that the master server and this media server have compatible software
■
versions.
Added the host name of this media server to the
■
server that you plan to use with it.
See "Configuring a master server to communicate with an appliance media
server" on page 26.
Opened the appropriate ports on the master server if a firewall exists between
■
the master server and this media server.
command.
shell prompt, enter the
Support > Maintenance
Initial configuration procedures
Main_Menu
user password
Maintenance
command to change
passwd
command,
list on the master
SERVERS
43