Configuring The Ipmi From The Netbackup Appliance Shell Menu - VERITAS NetBackup 5330 Appliance Hardware Installation Manual

76 Hardware installation procedures

Configuring the IPMI from the NetBackup Appliance Shell Menu

Configuring the IPMI from the NetBackup
Appliance Shell Menu
A blinking, amber LED indicates that a RAID rebuild is in progress.
■
The Activity LED (2) indicates the following:
The LED is not lit when the disk has spun down, although power is still
■
on.
The LED is solid green when there is no disk activity, although power
■
is still on.
The LED blinks green when the disk spins up.
■
The LED blinks green occasionally when commands are processed.
■
13
Launch the NetBackup Appliance Web Console and verify that all devices
appear on the Monitor > Hardware page. If the devices do not appear, check
the cable connections and make sure that the power is on.
14
Proceed to the initial configuration of the appliance. Refer to instructions at the
following site.https://veritas.com/support/en_US/article.DOC2792.html
This section explains how to configure IPMI from the NetBackup Appliance Shell
Menu.
To configure IPMI from the NetBackup Appliance Shell Menu
1
Before starting the IPMI configuration, obtain the following information for the
appliance for which you want to configure the IPMI:
IP address IP address for the remote management port so that the default static
IP address of the remote management port can be changed.
Subnet mask Enable connectivity between your network computer and the remote
management port.
Gateway IP Enable connectivity between your network computer and the remote
address management port.
Also review the following section on IPMI prerequisites.
See "Prerequisites for IPMI configuration" on page 31.
2
Log on to the NetBackup Appliance Shell Menu.
3
Enter the username and password for the appliance. By default, the user name
is and the password is
admin
where 0 is the number zero.
P@ssw0rd