Netbackup 5330 Storage Shelves And Disk Drives - VERITAS NetBackup 5330 Installation Manual

NetBackup 5330 storage shelves and disk drives

NetBackup 5330 compute node PCIe Ethernet port configurations
Table 1-2
Option
A (four 10-Gb Ethernet cards)
B (three 10-Gb Ethernet cards)
C (two 10-Gb Ethernet cards)
D (one 10-Gb Ethernet card)
E (zero 10-Gb Ethernet cards)
The NetBackup 5330 compute node supports two types of external disk drive storage
as follows:
Primary Storage Shelf - required
■
Expansion Storage Shelf - optional
■
Note: A 220VAC power supply is required for the Primary Storage Shelf and the
Expansion Storage Shelf.
Each NetBackup 5330 compute node requires one Primary Storage Shelf. You can
install up to five expansion shelves to provide additional storage capacity. Refer to
the NetBackup 5330 Appliance Product Description for supported storage capacities
at the following website.
NetBackup Appliance documentation
Due to weight considerations, the storage shelves should be installed at or as close
to the bottom of the rack as is possible. When the storage shelves and the compute
node have been installed, the Fibre Channel (FC), SAS, and power cables are
connected between the units. The FC cables connect the compute node to the
Primary Storage Shelf. The SAS2 cables connect a Primary Storage Shelf to an
NetBackup 5330 storage shelves and disk drives
Slot and Ethernet port numbers
Slot 2: eth8 (right), eth9 (left)
■
Slot 3: eth6 (right), eth7 (left)
■
Slot 5: eth10 (right), eth11 (left)
■
Slot 6: eth12 (right), eth13 (left)
■
Slot 2: eth8 (right), eth9 (left)
■
Slot 3: eth6 (right), eth7 (left)
■
Slot 5: eth10 (right), eth11 (left)
■
Slot 2: eth8 (right), eth9 (left)
■
Slot 3: eth6 (right), eth7 (left)
■
Slot 3: eth6 (right), eth7 (left)
■
N/A
Hardware overview 10