Adjusting The Position Of The Speed Sensor - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

8.4. ADJUSTING THE POSITION OF THE SPEED SENSOR

Figure 8.4-1
Page 8.4
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
1. Loosen the 2 screws (a) using a 3mm Allen
wrench.
2. Move the speed sensor support sideways in
the direction of the yellow arrows, moving it
closer to or further away from the copper
disk up to a distance from the screws of
0.7mm.
3. Re-tighten the screws (a).