Adjusting The Position Of The Brake Unit - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1

8.5. ADJUSTING THE POSITION OF THE BRAKE UNIT

Figure 8.5-1
Figure 8.5-2
1. Disconnect the 2 fastons highlighted in the
figure.
2. Loosen the 2 screws (a) using a 4mm Allen
wrench.
3. Move the Brake Unit sideways in the
direction of the yellow arrows up to a
distance from the disk of 0.6mm.
4. Re-tighten the screws (a).
WARNING: In order to adjust the
brake correctly, do some pedalling at
high speed to check that there is no
contact with the flywheel.
DANGER:
measure the planarity of the copper
disk. It must have a margin of ±
0.15mm.
Using a comparator,
Page 8.5