The Speed Signal Is Not Correct - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

6.7. THE SPEED SIGNAL IS NOT CORRECT

The speed signal is not correct if:
1. The disk of the Electromagnetic Brake is incorrectly mounted on the flywheel;
2. The special speed measurement screws are missing or badly assembled (only for
Crossover)
3. The Speed Sensor (for the mains-powered boards) and the Generator (for the self-powered
boards) is defective or badly assembled;
4. the Brake Board was not programmed correctly with the sequence of:
a. Firmware (FW),
b. Brake Table;
c. Standard Settings.
5. The Brake Board is faulty.
Instal the latest v ersion of
YES
Firmware (FW), Brake
Table and carry out the
Standard Setting
Page 6.16
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
THE SPEED SIGNAL
IS INCORRECT
Carry out the
1
Standard Setting procedure
YES
2
NO
Does the speed sensor send
the correct signal to the
Brake Board?
YES
3
NO
Update the Low Kit SW.
Is the speed signal correct?
NO
Are the detection screws
present and/or assembled in
the right way ?
YES
Replace the
speed sensor
(generator on SP models)
Replace the
Brake Board
Reassembly in the
right way