Dismantling The Brake Board - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1

7.13. DISMANTLING THE BRAKE BOARD

Figure 7.13-1
Figure 7.13-2
Figure 7.13-3
Carry out the operations in the paragraph: 7.1.
"IMPORTANT NOTE ON DISMANTLING" and
7.7. "Dismantling the guard".
1. Remove the Brake
equipment, gripping it with your hands as
indicated by the orange arrows and pull in
the direction of the yellow arrows.
2. Remove the Brake Board from its housing.
3. Disconnect the 3 connectors highlighted in
the figure.
4. Unscrew the blocking screw (a) from the
mains power supply connector (b) and
disconnect it.
5. Remove the Brake Board (c).
To re-fit the Brake Board, follow the above
operations in reverse.
WARNING: If you replace the Brake
Board, be careful not to cover the
Board details and the SN with the
Velcro adhesive strip.
Board from the
Page 7.31