Disassembling The Pedal And The Pedal Lever With Guard - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
7.6. DISASSEMBLING THE PEDAL AND THE PEDAL LEVER WITH
GUARD
Figure 7.6-1
Figure 7.6-2
Figure 7.6-3
1. Unscrew the threaded pin (a) using a 15mm
wrench and remove the pedal.
WARNING:
tighten the screws (a) using a torque
wrench set at 32Nm.
In order to dismantle the pedal lever:
2. Unscrew the cap (b) using snap ring pincers
or with scissors.
3. Unscrew the bolt (c) which you gain access
to, using a 13mm socket wrench.
4. Remove the spacer (d).
5. Dismantle the pedal lever (e) using a
common bicycle pedal remover as shown in
the figure.
WARNING:
tighten the pedal lever using a torque
wrench set at 40Nm.
To re-fit the pedal and pedal lever, follow the
above operations in reverse.
During re-assembly,
During re-assembly,
Page 7.9