Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual page 53

Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
Follow the chart step by step in order to make a correct diagnosis. In particular, pay attention to
the checks highlighted in the numbered boxes and listed here below:
(1) Check on the correct SW version, according to the "EXCITE SW SMART TABLE" table
found in the TG Direct.
(2) Check on the correct positioning of the Receiver Board as indicated in paragraph: 7.4.
"Dismantling the Cardio Receiver" "HR Receiver (Band)".
(3) Insert the tips of the tester onto pins 1 and 2 on the CN1 connector on the receiver. They must
register +5Vdc.
(4) Do the same as in point (3) but between pins 1 and 8 on the CN3 connector of the CU208.
If the Display Board is replaced, check that the upgraded SW version is installed or
proceed with the upgrade.
Page 6.19