Accessories; Connection To The Pc For Programming - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1

4. ACCESSORIES

4.1. CONNECTION TO THE PC FOR PROGRAMMING

The equipment is connected to a PC for programming via the RJ45 connector of the C-Safe Board.
WARNING: in order to identify the numbering of the pins on the RJ45 connector,
you should refer to the following diagram:
While programming the equipment, sometimes you need to use an RJ45 plug on the
vacant RJ45 port on the back of the display, to avoid interference of any kind during
the operation.
The diagram of the RJ45 plug is as follows:
The RJ45 connection cable and plug are both available by ordering code R0002534AB.
Page 4.1