7.3.
DISMANTLING THE ARM AND C-SAFE BOARD
Figure 7.3-1
Figure 7.3-2
Figure 7.3-3
Page 7.4
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
Carry out the operations in the paragraph: 7.2.
"Dismantling the control panel" up to step 5.
Place the control panel on a workbench:
Now it is possible to remove the boards it
contains:
•
•
Dismantling the ARM board (a):
1. Unscrew the 4 screws highlighted in the
figure at side using a medium-sized Phillips
screwdriver.
Dismantling the C-Safe board (b):
2. Disconnect the flat cable highlighted in the
figure at side.
3. Remove the C-Safe board as indicated by the
yellow arrows.
In order to re-fit the Display Boards,
carry out the above operations in reverse.
The ARM board (a);
The C-Safe board (b).
During the reassembly, use some hot
glue to fix the C-Safe board again.
Continues on the next page...