Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual page 72

Figure 7.8-4
Figure 7.8-5
Figure 7.8-6
Page 7.14
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
4. Unscrew the 4 nuts (d) using a 13mm
wrench, while blocking the screws on the
opposite side, using a wrench of the same
size.
5. On the left-hand side of the equipment,
remove the snap ring (3), the spacer (2) and
the elastic spring (1).
6. Remove the pulley shaft (f)from the right-
hand side, as shown in the figure.
To re-fit the pulley unit, follow the above
WARNING:: During
position the screws at the top inside of
the flange before refitting the shaft
onto the frame.
WARNING: During
tighten the screws (d) using a torque
wrench set at 22Nm.
WARNING:: During re-fitting, take
care to re-insert the components
according to the sequence shown in
the figure.
operations in reverse.
re-assembly,
re-assembly,