7.12. DISMANTLING THE SPEED SENSOR
Figure 7.12-1
Page 7.30
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
Carry out the operations in the paragraph: 7.1.
"IMPORTANT NOTE ON DISMANTLING" and
7.7. "Dismantling the guard".
1. Unscrew the 2 screws (a) using a medium-
sized Phillips screwdriver.
2. Remove the speed sensor (b).
To re-fit the speed sensor, follow the above
operations in reverse.
WARNING: If you also remove the
sensor's plastic support, adjust the
position of the sensor, as described in
the paragraph: 8.4. "Adjusting the
position of the speed sensor".