Installation Instructions; Installation - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1

5. INSTALLATION INSTRUCTIONS

5.1. INSTALLATION

In order to install the equipment correctly, you need to proceed as follows:
1. The equipment is installed on a flat surface, where there are no vibrations and adequate weight
capacity also taking into consideration the weight of the user.
2. The environment must not be dusty or sandy.
3. The requirements regarding temperature and humidity levels must be complied with. See
paragraph: 2.4. "Environmental Characteristics".
4. The equipment must not be placed near heat sources or sources causing electromagnetic
disturbance (televisions, electric motors, aerials, high voltage cables, domestic appliances etc...)
and medical equipment.
5. In order to eliminate any disturbance on the cardio receiver, no transmitter must be within a
distance of 90cm from the display in: Figure 6-1 and Figure 6-2.
6. The mains voltage must be the same as the voltage indicated on the equipment label.
7. The electric circuit must have a good earth connection.
8. The electricity socket must be used exclusively for the equipment and have a power of at least
100VA.
9. Connect a maximum number of pieces of equipment in cascade according to the information in
paragraph: 3.7. "Input Module".
10. Place the power supply cable so that it will not get in anyone's way.
11. According to which country the equipment is going to, it may be sent partially assembled, sealed
within its cardboard packaging and fixed onto a pallet, or it may be fully assembled within a
transparent plastic wrap, fixed onto a wooden pallet.
Follow the assembly operations shown in the instruction sheets attached to the
equipment.
12. Connect the power supply cable to the equipment.
13. Position the start switch on position 0.
14. Connect the power supply cable to the socket.
Page 5.1