Led Test; Serial Ports Test; Manual Test; Man. Keyboard Test - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

6.1.1.2.

LED Test

The LED test checks on the functioning of all the LEDs in the display by turning on all the matrices.
The BUZZER is also tested by varying the frequency which causes a variation in the tone of the
sound.
The test does not issue any message with the test results, so you need to check the outcome visually.
6.1.1.3.

Serial Ports Test

The serial ports test performs a communication check on the connection ports using:
• C-Safe COM test;
• Low Kit COM test;
• TGS COM test.
By using the + and - difficulty level keys, select the test you require and confirm your choice by
pressing the ENTER key.
The test can produce two results:
• "Test Successful, press Enter to continue": This means the test was successful and that the
communication with the selected serial port is correct.
• "COMx error, press Enter to continue": This means the test was a failure and the term COM1
will be displayed if the communication test related to the C-Safe COM test, COM2 if relating to
communication with the Low Kit and COM3 if relating to communication of the TGS COM test.
A "TGS COM test" performed on equipment that does not have a TGS reader will
have a negative result as will a "C-Safe COM test" if the equipment is not connected
to the monitor plug indicated in paragraph: 4.2. "Monitor plug for C-Safe port".
6.1.2.
The tests that the equipment proposes in this section perform manual checks on some of the
peripheral devices.
After selecting the item for the test you require by using the + and - difficulty level keys, you access
the test by pressing the ENTER key.
To quit the test phase you press the CANCEL for a few seconds.
6.1.2.1.

Man. Keyboard Test

The keyboard manual test runs a check on all the keys on the keyboard.
Once you have accessed the test by pressing the ENTER key, a message will appear, saying "Press
all buttons (beep=OK)".
When you press each key a "beep" is produced but if a key fails to produce a "beep", it means it
does not work.
Page 6.4
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
M T
ANUAL EST