Low Kit Version; Config. Registers; Low Kit Fault Code; High Kit Version - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

9.2.5.1.

Low kit version

This function allows you to display the version of the Firmware (FW) of the Brake Board. In order
to access this menu, when the display shows:
press ENTER and the SW numerical sequence will be displayed:
Where:
• X = KERNEL
• Y = Brake Board
• Z = Brake Table
Which identifies the version of the Firmware (FW).
9.2.5.2.

Config. registers

This function allows to set on register at the time.
NOT used on FORLA LINE.
9.2.5.3.

Low Kit fault code

This function allows you to display any fault code which is blocking the low kit. In order to access
this menu, when the display shows:
if you press ENTER, the following message will be displayed:
If FAULT=00 is displayed, the Board is not at fault.
9.2.6. H
IGH KIT VERSION
This function allows you to display the version of the display SW. In order to display it, when the
display shows:
press ENTER and a message will be displayed which identifies the version of the SW.
Page 9.16
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
LOW KIT VERSION
X.Y.Z
LOW KIT FAULT CODE
FAULT=XX

HIGH KIT VERSION