8.6. THE EQUIPMENT IS NOT LEVEL
This problem may be due to the positioning of the equipment on an unflat surface. In order to
resolve the problem, you need to regulate the adjustment foot.
In order to make the equipment level, adjust the two front and rear feet.
1. Loosen the locknut (B), then tighten or unscrew the foot (A) until the frame is stable.
2. When you have finished the adjustment, tighten the locknut (B).
WARNING: During re-assembly, tighten the nuts (b) using a torque wrench set at a
maximum of 35Nm.
Page 8.6
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
Figure 8.6-1