Table of Contents
Advertisement
RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
5. INSTALLATION INSTRUCTIONS
5.1. SPECIFICATIONS AND REQUIREMENTS
For correct machine installation, make sure that:
1. The machine is installed on a level surface that is free of vibrations and has sufficient carrying
capacity for the combined weight of the machine and user.
2. The place of installation is free of dust and sand.
3. The place of installation meets the operating temperature and humidity conditions specified in
paragraph 2.4. "Ambient specifications".
4. The machine is not positioned close to sources of heat, sources of electromagnetic noise
(television sets, electrical motors, antennas, high voltage lines, household appliances, etc...) or
medical equipment.
5. To eliminate any interference with the cardio receiver, no transmitters should be placed less
than 1 meter from the display.
Only for the 500, 700 and 700E models:
6. The mains voltage must match the value specified on the machine rating plate.
7. The electrical system must be correctly earthed.
8. The wall outlet used should be reserved for the machine and have a rating of at least 50 VA.
9. The maximum number of machines connected in cascade should be that indicated in paragraph
3.1.10. "Power entry module".
10. Position the mains lead of the machine where it will not be underfoot.
5.2. SPECIFICATIONS AND REQUIREMENTS TO INSTALL A
WELLNESS TV MACHINE
1. Ensure that the specifications and requirements for installation have been met (see paragraph
5.1. "Specifications and requirements").
2. To obtain a good video signal, the S/N ratio at the antenna signal input of a Wellness TV
machine should be between 70 and 80 dB.
WARNING: If the machine is not connected to a terrestrial antenna--or if it is but the
antenna signal line is interrupted by devices such as TV distribution units, modulators, etc.--
the machine will not be able to receive a usable antenna signal for radio channel tuning.
Page 5.1
Advertisement
Table of Contents
Troubleshooting
