Accessories; Connecting To The Tgs; Connecting To The Printer - Technogym spin trainer Maintenance Manual

SPIN TRAINER: Service & Maintenance Manual - rev. 2.0

4. ACCESSORIES

4.1.

CONNECTING TO THE TGS

The machine can be connected to the Technogym System by means of the 9-pin D-type connector
situated on the back of the display, which provides the RS 232 serial port for connecting the TGS
reader.
Although this serial port is the same one used for connecting to a serial printer, the cable
for connecting this serial port to the CPU is different from the one used for connecting to
the printer.
The serial port is connected to the CPU by the cable described below, which is supplied in the
upgrade kit:
CPU/CN2
1
2
5
6
To prevent interference with the cardio receiver, route the cable behind cable SP-1 and
connector CN1 of the CPU board.
For all further information, including troubleshooting, refer to the following manual: "Technogym
System: Installation Guide".
4.2.

CONNECTING TO THE PRINTER

The machine can be connected to a printer through the 9-pin D-type connector situated on the back
of the display, which provides the RS 232 serial port for connecting the printer with the following
cable:
DB9
2
3
5
TGSRN2XT: Internal cable
CPU - 9 pin connector
Signal
+ 12 V
Tx
Rx
ground
A441: Printer cable
CPU – 9 pin connector
Signal
Tx
Rx
ground
Color DB9 male
yellow 1
brown 3
white 2
green 5
Color DB25
Brown 3
Blue 2
Black 7
Page 4.1