Accessories; Connecting To The Tgs; Connecting To The Cardio Theater - Technogym Top 600 XTPRO Service Maintenance Manual

TOP 600 XTPRO: Service & Maintenance Manual - rev. 2.0

4. ACCESSORIES

4.1. CONNECTING TO THE TGS

The machine is connected to the Technogym System by means of the 9 pin male D-connector,
situated on the back of the control panel, which provides the RS 232 serial port for connecting the
TGS reader. The connecting cable is already directly connected to the TGS reader itself:
Control panel
DB9 male
1
5
3
2
For all further information, including troubleshooting, refer to the following manual: "Wellness
System: Installation Guide".

4.2. CONNECTING TO THE CARDIO THEATER

The machine is connected to the Cardio Theater by means of an RJ45 connector which has the
following pin out:
On the RJ45 connector, which is illustrated below, pin 1 is the one on the far right, with the locking
tab facing upward.
The remaining pins are not connected.
TGSRN1: Connecting cable
Control panel – Retrofit
Signal
+12 Vdc
Ground
Rx
Tx
RJ45 Connector Signal
5 + 5 Vdc
7 Ground
Color Retrofit
Yellow 8
Green 6
Brown 2
White 1
Page 4.1