Appendix B Setpoint Parameters - Satec expertmeter EM720 Operation Manual

Appendix B Setpoint Parameters

Appendix B
Action
NONE
SET EVENT FLAG
CLEAR EVENT FLAG
OPERATE RELAY
RELEASE RELAY
INCREMENT COUNTER
CLEAR COUNTER
RESET ALL COUNTERS
RESET DEMANDS
RESET DEMANDS
RESET DEMANDS
RESET DEMANDS
RESET DEMANDS
RESET DEMANDS
RESET TOU DEMANDS
CLEAR MIN/MAX LOG
EVENT LOG
EVENT LOG
EVENT LOG
DATA LOG
WAVEFORM LOG
SEND NOTIFICATION
194
Setpoint Parameters
Setpoint Triggers
For setpoint
Monitoring and Logging.
Setpoint Actions
The available setpoint actions are listed in the following table.
Setpoint Actions
Target
No action
1-8 Set user event flag 1-8
1-8 Clear user event flag 1-8
1-4 Operate relay RO1-RO4
1-4 Release latched relay RO1-RO4
1-8 Increment counter 1-8
1-8 Clear counter 1-8
Clear all counters
ALL Reset all engineering maximum demands
POWER Reset engineering maximum power demands
VOLT/AMP Reset maximum volts and ampere demand
VOLT Reset maximum volt demand registers
AMP Reset maximum ampere demand registers
HRM Reset maximum harmonic demand registers
Reset billing/TOU maximum demands (end of billing period)
Clear Min/Max log
OPER Event log on setpoint operated
RELS Event log on setpoint released
ANY Event log on any setpoint transition
1-14 Conventional data log 1-14
1-2 Waveform Log 1-2
Send a notification message to a remote TCP server
triggers, see Appendix
Description
EM720 Power Quality and Revenue Meter
A Parameters for