Identification; Application; Setting Guidelines; Single Point Generic Control 8 Signals Spc8Gapc - ABB REB670 Applications Manual

Section 12
Control
12.7.1
12.7.2
12.7.3
12.8
12.8.1
12.8.2
378

Identification

Function description
Generic communication function for
Double Point indication

Application

DPGAPC function block is used to combine three logical input signals into a two bit
position indication, and publish the position indication to other systems, equipment or
functions in the substation. The three inputs are named OPEN, CLOSE and VALID.
DPGAPC is intended to be used as a position indicator block in the interlocking
stationwide logics.
The OPEN and CLOSE inputs set one bit each in the two bit position indication,
POSITION. If both OPEN and CLOSE are set at the same time the quality of the output
is set to invalid. The quality of the output is also set to invalid if the VALID input is not
set.

Setting guidelines

The function does not have any parameters available in the local HMI or PCM600.

Single point generic control 8 signals SPC8GAPC

Identification
Function description
Single point generic control 8 signals
Application
The Single point generic control 8 signals (SPC8GAPC) function block is a collection of
8 single point commands, designed to bring in commands from REMOTE (SCADA) to
those parts of the logic configuration that do not need complicated function blocks that
have the capability to receive commands (for example SCSWI). In this way, simple
commands can be sent directly to the IED outputs, without confirmation. Confirmation
IEC 61850 IEC 60617
identification identification
DPGAPC -
IEC 61850 IEC 60617
identification identification
SPC8GAPC -
1MRK 505 337-UUS -
ANSI/IEEE C37.2
device number
-
ANSI/IEEE C37.2
device number
-
Application manual