Configuring Igmp Ssm Mappings; Configuration Prerequisites; Configuration Procedure; Configuring Igmp Proxying - HP VSR1000 Configuration Manual

To enable fast-leave processing:
Step
Enter system view.
1.
Enter interface view.
2.
Enable fast-leave
3.
processing.

Configuring IGMP SSM mappings

This feature enables the device to provide SSM services for IGMPv1 or IGMPv2 hosts.
This feature does not process IGMPv3 messages. As a best practice, enable IGMPv3 on the
receiver-side interface to avoid IGMPv3 hosts failing to join multicast groups.

Configuration prerequisites

Before you configure IGMP SSM mappings, complete the following tasks:
•
Configure any unicast routing protocol so that all devices in the domain can interoperate at the
network layer.
•
Configure basic IGMP features.

Configuration procedure

To configure an IGMP SSM mapping:
Step
Enter system view.
1.
Enter IGMP view.
2.
Configure an IGMP
3.
SSM mapping.

Configuring IGMP proxying

This section describes how to configure IGMP proxying.
Configuration prerequisites
Before you configure the IGMP proxying feature, complete the following tasks:
Configure a unicast routing protocol so that all devices in the domain can interoperate at the
1.
network layer.
Determine the router interfaces and host interfaces based on the network topology.
2.
Enable IGMP on the router interfaces.
3.
Command
system-view
interface interface-type
interface-number
igmp fast-leave [ group-policy
ipv4-acl-number ]
Command
system-view
igmp [ vpn-instance
vpn-instance-name ]
ssm-mapping source-address
ipv4-acl-number
47
Remarks
N/A
N/A
By default, fast-leave processing
is disabled.
Remarks
N/A
N/A
By default, no IGMP SSM
mappings exist.