Table of Contents
Advertisement
10. Reinstall the left top panel (see Figure 4-5) and secure using the retained
NOTE Three flat cabinet joining brackets are provided in the hardware kit for securing the ISBM and UPM
sections at the top front, top rear, and front base (see Steps 11 and 12).
11. Locate the hardware kit (packed inside a drawstring bag tied to the left middle
12. Locate one flat bracket and screws from the hardware kit. Align the holes in the
13. Proceed to paragraph 4.4.
EATON Powerware
®
9395 UPS (1000–1100 kVA) Installation and Operation Manual
UPM Wireway
(Power wiring harnesses
are coiled in this area.)
Figure 4-6. ISBM and UPM Sections Joined
hardware.
panel of the UPM section). Locate two flat brackets and screws from the
hardware kit. Align the holes in the flat brackets over holes in the top rear and
top front of the ISBM and UPM sections. Secure the brackets with the screws
from the hardware kit (see Figure 4-7).
flat bracket over holes in the front base of the ISBM and UPM sections. Secure
the bracket with the screws from the hardware kit (see Figure 4-7).
UPS SYSTEM INSTALLATION
S
164201764 Rev 1 www.powerware.com
4−7
Advertisement
Table of Contents
