Page 1
Powerware Series ® Eaton 9395 UPS 650–825 kVA Single-Feed Kit Installation Instructions...
Page 2
If not already accomplished, remove one top screw and two bottom screws securing each ISBM section left and right front panel (refer to the applicable Eaton 9395 UPS manual for panel location). Lift the panels straight up to remove them from the panel hanger brackets at the top of the cabinet.
Page 3
Using tie wraps from the single-feed kit (see Table 1), secure cables to the internal cabinet divider (see Figure 1). Return to the applicable Eaton 9395 UPS manual to complete the wiring. Use M12 50mm bolts from the single-feed kit (see Table 1) to install rectifier input lugs.
Need help?
Do you have a question about the Powerware Series and is the answer not in the manual?
Questions and answers