Table of Contents
Advertisement
Chapter 5
Figure 5Table 5
5.1
Installing an Optional Powerware Hot Sync CAN Bridge Card
EATON Powerware
Installing Options and Accessories
As an option, a Powerware Hot Sync Controller Area Network (CAN) Bridge Card,
shown in Figure 5-1, can be installed to provide connectivity for operational mode
control of a parallel system. In addition, this card can be used to connect optional
system monitoring devices, such as a Remote Monitor Panel II, a Relay Interface
Module II, or a Supervisory Contact Module II to the UPS.
NOTE Only one Powerware Hot Sync CAN Bridge Card can be installed in the UPS. Multiple CAN cards are
not supported and will cause system conflicts.
To install the card:
1.
Verify the UPS system is turned off and all power sources are removed. See
Chapter 7, UPS Operating Instructions," for shutdown instructions.
2.
Unfasten the front door latch and swing the door open (see Figure 4-1 on
page 4−2).
3.
Install the Powerware Hot Sync CAN Bridge Card into an open X−Slot
communication bay on the front of the UPS. See Figure 4-22 on page 4−27 and
Figure 4-28 on page 4−33 for X−Slot communication bay locations.
®
9395 UPS (1000–1100 kVA) Installation and Operation Manual
Figure 5-1. Powerware Hot Sync CAN Bridge Card
S
164201764 Rev 1 www.powerware.com
Plug−in Terminal
Block J3
5−1
Advertisement
Table of Contents
