Page 1
Powerware Series ® Eaton 9395 Field Installed UPM Mechanical Installation Manual...
Page 2
Eaton is a registered trademark of Eaton Corporation or its subsidiaries and affiliates. ECopyright 2008–2009 Eaton Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced in any way without the express written approval of Eaton Corporation.
Engineer, or the warranty terms specified on page W−1 become void. This service is offered as part of the sales contract for the FI−UPM. Contact an Eaton service representative in advance (usually a two−week notice is required) to request service.
A question this manual does not answer Please call the Eaton Help Desk at: 1−800−843−9433 1−919−870−3028 United States: 1−800−461−9166 ext 260 Canada: Call your local service representative All other countries: 1−4 EATON 9395 Field Installed UPM Mechanical Installation Manual 164201717 Rev 3 www.eaton.com/powerquality...
The operating environment should be maintained within the parameters stated in this manual. Keep surroundings uncluttered, clean, and free from excess moisture. Observe all DANGER, CAUTION, and WARNING notices affixed to the inside and outside of the equipment. 2−1 EATON 9395 Field Installed UPM Mechanical Installation Manual 164201717 Rev 3 www.eaton.com/powerquality...
Page 10
SAFETY WARNINGS This page intentionally left blank. 2−2 EATON 9395 Field Installed UPM Mechanical Installation Manual 164201717 Rev 3 www.eaton.com/powerquality...
Engineer, or the warranty terms specified on page W−1 become void. This service is offered as part of the sales contract for the FI−UPM. Contact an Eaton service representative in advance (usually a two−week notice is required) to request service.
Page 12
43 (10943) 225 kVA 480/480 44 (11054) Approximately 400/400 53 (13375) 755 liter/sec 275 kVA 480/480 54 (13510) (1600 cfm) 400/400 51 (12969) 300 kVA 480/480 51 (12969) 3−2 EATON 9395 Field Installed UPM Mechanical Installation Manual 164201717 Rev 3 www.eaton.com/powerquality...
Carefully inspect the outer packaging for evidence of damage during transit. C A U T I O N Do not install a damaged cabinet. Report any damage to the carrier and contact an Eaton service representative immediately. NOTE For the following step, verify that the forklift or pallet jack is rated to handle the weight of the cabinet (see Table 3-1 on page 3−2 for cabinet weight).
Page 16
Inspect the contents for any evidence of physical damage, and compare each item with the Bill of Lading. If damage has occurred or shortages are evident, contact an Eaton service representative immediately to determine the extent of the damage and its impact on further installation.
(see Figure 4-1). Remove the left side shipping bracket. If installing the cabinet permanently, retain the shipping bracket and securing hardware for later use. 4−1 EATON 9395 Field Installed UPM Mechanical Installation Manual 164201717 Rev 3 www.eaton.com/powerquality...
Pull the pallet from under the FI−UPM cabinet. Discard or recycle the pallet and unused shipping brackets in a responsible manner. Carefully lower the FI−UPM cabinet until the cabinet base contacts the floor. 4−2 EATON 9395 Field Installed UPM Mechanical Installation Manual 164201717 Rev 3 www.eaton.com/powerquality...
Remove and retain one top screw and two bottom screws securing the FI−UPM front panel (see Figure 4-2). Lift the panel straight up to remove it from the panel hanger bracket at the top of the cabinet. 4−3 EATON 9395 Field Installed UPM Mechanical Installation Manual 164201717 Rev 3 www.eaton.com/powerquality...
Service Engineer, or the warranty terms specified on page W−1 become void. This service is offered as part of the sales contract for the FI−UPM. Contact an Eaton service representative in advance (usually a two−week notice is required) to reserve a preferred startup date.
Page 22
- A 120 Vac or 230 Vac service outlet (depending on local mains voltage) is located within 7.5 meters (25 feet) of the UPS equipment. - The debris shield covering the FI−UPM cabinet ventilation grill is removed. - Startup and operational checks are performed by an authorized Eaton Customer Service Engineer. 4−6 EATON 9395 Field Installed UPM Mechanical Installation Manual...
Eaton−built battery cabinets (individually and collectively, the "Warranted Items") are free from defects in material and workmanship. If, in the opinion of Eaton, a Warranted Item is defective and the defect is within the terms of this Warranty, Eaton’s sole obligation will be to repair or replace such defective item (including by providing service, parts, and labor, as applicable), at the option of Eaton.
Page 26
WARRANTY This page intentionally left blank. W−2 EATON 9395 Field Installed UPM Mechanical Installation Manual 164201717 Rev 3 www.eaton.com/powerquality...
Need help?
Do you have a question about the Powerware Series and is the answer not in the manual?
Questions and answers