Cisco Nexus 5500 Series Command Reference Manual page 243

Chapter S Commands
switchport monitor rate-limit
To configure a rate limit to monitor traffic on an interface, use the switchport monitor rate-limit
command. To remove a rate limit, use the no form of this command.
Syntax Description
1G
Command Default None
Command Modes Interface configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to limit the bandwidth on Ethernet interface 1/2 to 1 GB:
switch(config)# interface ethernet 1/2
switch(config-if)# switchport monitor rate-limit 1G
switch(config-if)#
Related Commands Command
show interface
switchport
switchport
private-vlan
association trunk
OL-27880-02
switchport monitor rate-limit 1G
no switchport monitor rate-limit [1G]
(Optional) Specifies that the rate limit is 1 GB.
Modification
This command was introduced.
Description
Displays information on all interfaces configured as switch ports.
Associates the isolated trunk port with the primary and secondary VLANs
of a private VLAN.
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
switchport monitor rate-limit
1237