Cisco Nexus 5500 Series Command Reference Manual page 228

svs veth auto-setup
svs veth auto-setup
To enable the Virtual Supervisor Module (VSM) to automatically create a virtual Ethernet interface
when a new port is activated on a host, use the svs veth auto-setup command. To remove this control,
use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
Enabled
Command Modes Global configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to enable automatic creation and configuration of virtual Ethernet interfaces:
switch# configure terminal
switch(config)# svs veth auto-setup
switch(config)#
This example shows how to disable automatic creation and configuration of virtual Ethernet interfaces:
switch# configure terminal
switch(config)# no svs veth auto-setup
switch(config)#
Related Commands Command
interface vethernet
show svs connections
svs veth auto-delete
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1222
svs veth auto-setup
no svs veth auto-setup
Modification
This command was introduced.
Description
Creates a virtual Ethernet interface.
Displays SVS connection information.
Enables the VSM to automatically delete DVPorts no longer used by a vNIC
or hypervisor port.
Chapter S Commands
OL-27880-02