Mvr Vlan - Cisco Nexus 5500 Series Command Reference Manual

Chapter M Commands

mvr vlan

To configure a Multicast VLAN Registration (MVR) VLAN for an interface, use the mvr vlan
command. To remove the MVR VLAN from an interface, use the no form of this command.
Syntax Description
vlan_ID
Command Default None
Command Modes Interface configuration mode
Virtual Ethernet interface configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines You can use this command on the following interfaces:
•
•
Before you use a virtual Ethernet interface, you must enable the Cisco Virtual Machine Fabric Extender
(VM-FEX) on the switch by using the feature vmfex command.
This command does not require a license.
Examples This example shows how to configure an MVR VLAN for an interface:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# mvr vlan 1
switch(config-if)#
Related Commands Command
feature vmfex
interface vethernet
show mvr
show running-config
OL-27880-02
mvr vlan vlan_ID
no mvr vlan vlan_ID
MVR VLAN ID. The range is from 1 to 4094.
Modification
This command was introduced.
Ethernet interface
Virtual Ethernet interface
Description
Enables VM-FEX on the switch.
Configures a virtual Ethernet interface on the switch.
Displays information about MVRs.
Displays the running system configuration information.
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
mvr vlan
1119