Cisco Nexus 5500 Series Command Reference Manual page 343

Chapter Show Commands
show port-channel compatibility-parameters
To display the parameters that must be the same among the member ports in order to join an
EtherChannel interface, use the show port-channel compatibility-parameters command.
Syntax Description This command has no arguments or keywords.
Command Default
None
Command Modes
EXEC mode
Command History Release
5.2(1)N1(1)
Examples
This example shows how to display the EtherChannel interface parameters:
switch# show port-channel compatibility-parameters
* port mode
Members must have the same port mode configured.
* port mode
Members must have the same port mode configured, either E,F or AUTO. If
they are configured in AUTO port mode, they have to negotiate E or F mode
when they come up. If a member negotiates a different mode, it will be
suspended.
* speed
Members must have the same speed configured. If they are configured in AUTO
speed, they have to negotiate the same speed when they come up. If a member
negotiates a different speed, it will be suspended.
* MTU
Members have to have the same MTU configured. This only applies to ethernet
port-channel.
* shut lan
Members have to have the same shut lan configured. This only applies to
ethernet port-channel.
* MEDIUM
Members have to have the same medium type configured. This only applies to
ethernet port-channel.
OL-27880-02
show port-channel compatibility-parameters
Modification
This command was introduced.
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
show port-channel compatibility-parameters
1337