Cisco Nexus 5500 Series Command Reference Manual page 288

show interface capabilities
show interface capabilities
To display detailed information about the capabilities of an interface, use the show interface
capabilities command.
Syntax Description ethernet
slot/[QSFP-module/]port
Command Default None
Command Modes EXEC mode
Command History Release
6.0(2)N1(1)
5.2(1)N1(1)
Usage Guidelines
You can use the show interface capabilities command only for physical interfaces.
Examples
This example shows how to display the interface capabilities for a specific interface:
switch# show interface ethernet 1/1 capabilities
Ethernet1/1
Model:
Type (SFP capable):
Speed:
Duplex:
Trunk encap. type:
Channel:
Broadcast suppression: no
Flowcontrol:
Rate mode:
QOS scheduling:
CoS rewrite:
ToS rewrite:
SPAN:
UDLD:
MDIX:
Link Debounce:
Link Debounce Time:
Pvlan Trunk capable:
TDR capable:
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1282
show interface ethernet slot/[QSFP-module/]port capabilities
Modification
Support for the QSFP+ GEM was added.
This command was introduced.
N6K-C6004-M12Q-FIX
unknown
40000
full
802.1Q
yes
rx-(off/on),tx-(off/on)
none
rx-(6q1t),tx-(1p6q0t)
no
no
yes
yes
no
yes
yes
yes
no
Specifies an Ethernet interface slot number and port number. The slot
number is from 1 to 255. The QSFP-module number is from 1 to 4.
The port number is from 1 to 128.
The QSFP-module number applies only to the QSFP+ Generic
Note
Expansion Module (GEM).
Chapter Show Commands
OL-27880-02