Show Mvr Interface - Cisco Nexus 5500 Series Command Reference Manual

show mvr interface

show mvr interface
To display information about Multicast VLAN Registration (MVR) interfaces, use the show mvr
interfaces command.
Syntax Description ethernet
slot/[QSFP-module/]port
port-channel
channel-num
vethernet veth-num
Command Default None
Command Modes EXEC mode
Command History Release
6.0(2)N1(1)
5.2(1)N1(1)
Examples This example shows how to display information about MVR interfaces:
switch# show mvr interface
a) Interface is not a switchport.
b) MVR receiver is not in access, pvlan host or pvlan promiscuous mode.
c) MVR source is in fex-fabric mode.
switch#
Related Commands Command
mvr group
mvr type
mvr vlan
show mvr members
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1332
show mvr interface [ethernet slot/[QSFP-module/]port | port-channel channel-num | vethernet
veth-num]
(Optional) Displays information about Ethernet IEEE 802.3z
interfaces.The slot number is from 1 to 255. The QSFP-module number is
from 1 to 4. The port number is from 1 to 128.
Note
(Optional) Displays information about EtherChannel interfaces. The
range is from 1 to 4096.
(Optional) Displays information about virtual Ethernet interfaces. The
range is from 1 to 1048575.
Modification
Support for the QSFP+ GEM was added.
This command was introduced.
Description
Configures an MVR group for an interface.
Configures an MVR port type for an interface.
Configures an MVR VLAN for an interface.
Displays the active MVR groups.
The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
Chapter Show Commands
OL-27880-02