Cisco Nexus 5500 Series Command Reference Manual page 44

destination (ERSPAN)
destination (ERSPAN)
To configure an Encapsulated Remote Switched Port Analyzer (ERSPAN) destination IP address, use
the destination command. To remove the destination ERSPAN IP address, use the no form of this
command.
Syntax Description
ip
ip_address
Command Default None
Command Modes ERSPAN session configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines You can configure only one destination IP address for an ERSPAN source session.
This command does not require a license.
Examples This example shows how to configure an ERSPAN destination IP address:
switch# configure terminal
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# destination ip 192.0.3.1
switch(config-erspan-src)#
Related Commands Command
monitor session
show monitor session
show running-config
monitor
source (SPAN session) Configures a source SPAN port.
source (ERSPAN
session)
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
138
destination ip ip_address
no destination ip ip_address
Configures the remote IP address.
IPv4 address in the format A.B.C.D.
Modification
This command was introduced.
Description
Creates a new SPAN session configuration.
Displays SPAN session configuration information.
Displays the running configuration information of a SPAN session.
Configures a source VLAN or VSAN interface.
Chapter D Commands
OL-27880-02