Cisco Nexus 5500 Series Command Reference Manual page 56

errdisable recovery interval
errdisable recovery interval
To configure the recovery time interval to bring the interface out of the error-disabled (err-disabled)
state, use the errdisable recovery interval command. To revert to the defaults, use the no form of this
command.
Syntax Description
time
Command Default
Disabled
Command Modes Global configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines When error disable recovery is enabled, the interface automatically recovers from the err-disabled state,
and the device retries bringing the interface up.
The device waits 300 seconds to retry.
Examples This example shows how to enable error disable recovery time interval to 100 seconds:
switch(config)# errdisable recovery interval 100
switch(config)#
Related Commands Command
errdisable recovery
cause
show interface status
err-disabled
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
150
errdisable recovery interval time
no errdisable recovery interval
Error disable recovery time interval. The range is from 30 to 65535 seconds.
Modification
This command was introduced.
Description
Enables an error disabled recovery on an interface.
Displays the interface error disabled state.
Chapter E Commands
OL-27880-02