Cisco Nexus 5500 Series Command Reference Manual page 11

Chapter B Commands
bind (virtual Ethernet interface)
To bind an interface to a virtual Ethernet interface, use the bind command. To remove the binding of an
interface, use the no form of this command.
Syntax Description
interface ethernet
slot/[QSFP-module/]port
channel
number
Command Default
Disabled
Command Modes Virtual Ethernet interface configuration mode
Command History Release
6.0(2)N1(2)
5.2(1)N1(1)
Examples This example shows how to bind a virtual Ethernet interface 10 to an Ethernet interface:
switch(config)# interface vethernet 10
switch(config-if)# bind interface ethernet 1/1 channel 101
switch(config-if)#
Related Commands Command
interface vethernet
show interface
ethernet
OL-27880-02
bind interface ethernet slot/[QSFP-module/]port channel number
no bind interface ethernet slot/[QSFP-module/]port channel number
Specifies that the virtual Ethernet interface be bound to a specified
Ethernet interface.
Ethernet interface slot number and port number. The slot number is from
1 to 255. The QSFP-module number is from 1 to 4. The port number is
from 1 to 128.
Note
Specifies that the virtual Ethernet interface be bound to a specified
EtherChannel interface.
EtherChannel number. The range is from 1 to 65535.
Modification
Support for the QSFP+ GEM.
This command was introduced.
Description
Configures a virtual Ethernet interface.
Displays information about Ethernet interfaces.
The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
bind (virtual Ethernet interface)
15