Cisco Nexus 5500 Series Command Reference Manual page 226

svs veth auto-delete
svs veth auto-delete
To enable the Virtual Supervisor Module (VSM) to automatically delete Distributed virtual ports
(dvPorts) no longer used by a virtual NIC (vNIC) or hypervisor port, use the svs veth auto-delete
command. To disable this control, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
Enabled
Command Modes Global configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines
When enabled (the default), any virtual Ethernet interfaces that are in the administratively down state
will be deleted after confirming with the vCenter server that no corresponding vNICs are in use.
This command does not require a license.
Examples This example shows how to enable the Virtual Supervisor Module (VSM) to automatically delete dvPorts
no longer used by a vNIC or hypervisor port:
switch# configure terminal
switch(config)# svs veth auto-delete
switch(config)#
This example shows how to disable the automatic deletion of dvPorts that are no longer used by a vNIC
or hypervisor port:
switch# configure terminal
switch(config)# no svs veth auto-delete
switch(config)#
Related Commands Command
interface vethernet
show svs connections
svs veth auto-setup
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1220
svs veth auto-delete
no svs veth auto-delete
Modification
This command was introduced.
Description
Creates a virtual Ethernet interface.
Displays SVS connection information.
Enables the VSM to automatically create a virtual Ethernet interface when
a new port is activated on a host.
Chapter S Commands
OL-27880-02