Cisco Nexus 5500 Series Command Reference Manual page 238

switchport mode
switch(config-if)# switchport mode vntag
switch(config-if)#
This example shows how to set a virtual Ethernet interface in trunk port mode:
switch# configure terminal
switch(config)# interface vethernet 1
switch(config-if)# switchport mode trunk
switch(config-if)#
Related Commands Command
interface vethernet
show interface
ethernet
show interface
switchport
switchport access vlan Sets the access VLAN when the interface is in access mode.
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1232
Description
Configures a virtual Ethernet interface.
Displays information about a specified Ethernet interface.
Displays information on all interfaces configured as switch ports.
Chapter S Commands
OL-27880-02