Cisco Nexus 5500 Series Command Reference Manual page 84

Nx-os layer 2 interfaces command reference
Hide thumbs Also See for Nexus 5500 Series:
Table of Contents

Advertisement

interface ethernet (Layer 3)
interface ethernet (Layer 3)
To configure a Layer 3 Ethernet IEEE 802.3 routed interface, use the interface ethernet command.
Syntax Description
chassis_ID
slot
QSFP-module
port
.
subintf-port-no
Command Default
None
Command Modes
Global configuration mode
Interface configuration mode
Command History
Release
6.0(2)N1(1)
5.2(1)N1(1)
Usage Guidelines
You must use the no switchport command in the interface configuration mode to configure the interface
as a Layer 3 routed interface. When you configure the interface as a Layer 3 interface, all Layer 2 specific
configurations on this interface are deleted.
Use the switchport command to convert a Layer 3 interface into a Layer 2 interface. When you configure
the interface as a Layer 2 interface, all Layer 3 specific configurations on this interface are deleted.
Examples
This example shows how to enter configuration mode for a Layer 3 Ethernet interface 1/5:
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# ip address 10.1.1.1/24
switch(config-if)#
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
178
interface ethernet [chassis_ID/] {slot/[QSFP-module/]port[.subintf-port-no]}
(Optional) Specifies the Fabric Extender chassis ID. The chassis ID is from
100 to 199.
Note
Slots from 1 to 4. The following list defines the slots available:
The QSFP-module numbers are from 1 to 4.
Note
Port number within a particular slot. The port number is from 1 to 128.
(Optional) Specifies the subinterface separator.
(Optional) Port number for the subinterface. The range is from 1 to 48.
Modification
Support for the QSFP+ GEM was added.
This command was introduced.
This argument is not optional when addressing the host interfaces of
a Cisco Nexus 2000 Series Fabric Extender.
Slot 1 are the fixed ports.
Slots 2 to 4 are expansion modules.
The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
Chapter
I Commands
OL-27880-02

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents