Cisco Nexus 5500 Series Command Reference Manual page 115

Chapter M Commands
management
To configure a switch virtual interface (SVI) that should be used for in-band management, use the
management command. To remove the in-band management access to a VLAN interface IP address, use
the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes Interface configuration mode
Switch profile configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines
You can use this command on a VLAN interface.
Examples
This example shows how to configure a VLAN interface to allow in-band management access:
switch# configure terminal
switch(config)# interface vlan 5
switch(config-if)# management
switch(config-if)#
This example shows how to remove the in-band management access to a VLAN interface:
switch# configure terminal
switch(config)# interface vlan 5
switch(config-if)# no management
switch(config-if)#
Related Commands Command
show running-config
interface
OL-27880-02
management
no management
Modification
This command was introduced.
Description
Displays the running configuration information for an interface.
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
management
1109