Show Mvr Members - Cisco Nexus 5500 Series Command Reference Manual

Chapter Show Commands

show mvr members

To display the active Multicast VLAN Registration (MVR) groups and receiver members, use the show
mvr members command.
Syntax Description count
interface
ethernet
slot/[QSFP-module/]port
port-channel
channel-num
vethernet veth-num
vlan vlan-ID
Command Default None
Command Modes
EXEC mode
Command History Release
6.0(2)N1(1)
5.2(1)N1(1)
Examples
This example shows how to display the active MVR groups:
switch# show mvr members
Related Commands Command
mvr group
mvr type
mvr vlan
show mvr
OL-27880-02
show mvr members [count | interface [ethernet slot/[QSFP-module/]port | port-channel
channel-num | vethernet veth-num] | vlan vlan-ID]
(Optional) Displays the active MVR groups on each MVR VLAN.
(Optional) Displays the active MVR groups configured on an interface.
(Optional) Displays the active MVR groups configured on an Ethernet
IEEE 802.3z interface.The slot number is from 1 to 255. The
QSFP-module number is from 1 to 4. The port number is from 1 to 128.
Note
(Optional) Displays the active MVR groups configured on an
EtherChannel interface. The range is from 1 to 4096.
(Optional) Displays the active MVR groups configured on a virtual
Ethernet interface. The range is from 1 to 1048575.
(Optional) Displays the active MVR groups on VLANs. The range is
from 1 to 4094.
Modification
Support for the QSFP+ GEM was added.
This command was introduced.
Description
Configures an MVR group for an interface.
Configures an MVR port type for an interface.
Configures an MVR VLAN for an interface.
Displays general information about MVRs.
The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
show mvr members
1333