Cisco Nexus 5500 Series Command Reference Manual page 428

show vtp interface
show vtp interface
To display the VLAN Trunking Protocol (VTP) interface status and configuration information, use the
show vtp interface command.
Syntax Description ethernet
slot/[QSFP-module/]port
port-channel channel-no (Optional) Displays the VTP configuration on EtherChannel interfaces.
Command Default None
Command Modes EXEC mode
Command History Release
6.0(2)N1(1)
5.2(1)N1(1)
Usage Guidelines Before you use this command, you must enable VTP on the switch by using the feature vtp command.
Examples
This example shows how to display the VTP configuration information on all interfaces:
switch# show vtp interface
Interface
--------------------------------
port-channel23
port-channel67
port-channel400
port-channel1504
Ethernet1/2
Ethernet1/12
switch#
This example shows how to display the VTP configuration information for an Ethernet interface:
switch# show vtp interface ethernet 1/12
Interface
--------------------------------
Ethernet1/12
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1422
show vtp interface [ethernet slot/[QSFP-module/]port | port-channel channel-no]
(Optional) Displays the VTP configuration on Ethernet interfaces. The
slot number is from 1 to 255. The QSFP-module number is from 1 to 4.
The port number is from 1 to 128.
Note
The EtherChannel number can be from 1 to 4096.
Modification
Support for the QSFP+ GEM was added.
This command was introduced.
VTP Status
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
VTP Status
Enabled
The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
Chapter Show Commands
OL-27880-02