Mvr Group - Cisco Nexus 5500 Series Command Reference Manual

Chapter M Commands

mvr group

To configure a Multicast VLAN Registration (MVR) group for an interface, use the mvr group
command. To remove the MVR group from an interface, use the no form of this command.
Syntax Description group_IP_address
IP_prefix/length
count count_value
vlan vlan_ID
Command Default None
Command Modes Interface configuration mode
Virtual Ethernet interface configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines You can use this command on the following interfaces:
•
•
Before you use a virtual Ethernet interface, you must enable the Cisco Virtual Machine Fabric Extender
(VM-FEX) on the switch by using the feature vmfex command.
This command does not require a license.
Examples This example shows how to configure an MVR VLAN group for an interface:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# mvr group 192.0.2.1/12 vlan 1
switch(config-if)#
OL-27880-02
mvr group {group_IP_address | IP_prefix/length} [count count_value] [vlan vlan_ID [...vlan
vlan_ID]]
no mvr group {group_IP_address | IP_prefix/length} [count count_value] [vlan vlan_ID [...vlan
vlan_ID]]
Group IP address in the format A.B.C.D.
IP prefix and network mask length in the format x.x.x.x/m.
Specifies the count value. The range is from 1 to 64.
Specifies the global default MVR VLAN. The range is from 1 to 4094.
Modification
This command was introduced.
Ethernet interface
Virtual Ethernet interface
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
mvr group
1115