Cisco Nexus 5500 Series Command Reference Manual page 188

spanning-tree mst hello-time
spanning-tree mst hello-time
To set the hello-time delay timer for all the instances on the switch, use the spanning-tree mst hello-time
command. To return to the default settings, use the no form of this command.
Syntax Description
seconds
Command Default
2 seconds
Command Modes Global configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines If you do not specify the hello-time value, the value is calculated from the network diameter.
Examples This example shows how to set the hello-time delay timer:
switch(config)# spanning-tree mst hello-time 3
Related Commands Command
show spanning-tree
mst
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1182
spanning-tree mst hello-time seconds
no spanning-tree mst hello-time
Number of seconds to set the hello-time delay timer for all the instances on
the switch. The range is from 1 to 10 seconds.
Modification
This command was introduced.
Description
Displays the information about the MST protocol.
Chapter S Commands
OL-27880-02