Cisco Nexus 5500 Series Command Reference Manual page 225

Chapter S Commands
svs connection
To enable an SVS connection to connect a vCenter Server to a Cisco Nexus 5000 Series switch, use the
svs connection command. To disable an SVS connection, use the no form of this command.
Syntax Description
svs-name
Command Default
None
Command Modes Global configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines Only one SVS connection can be enabled per session.
This command does not require a license.
Examples This example shows how to enable an SVS connection:
switch# configure terminal
switch(config)# svs connection SVSConn
switch(config-svs-conn)#
This example shows how to disable an SVS connection:
switch# configure terminal
switch(config)# no svs connection SVSConn
switch(config)#
Related Commands Command
connect
protocol vmware-vim
show svs connections
remote
vmware dvs
OL-27880-02
svs connection svs-name
no svs connection svs-name
Name of the SVS connection. The name can be a maximum of 64
alphanumeric characters.
Modification
This command was introduced.
Description
Initiates a connection with a vCenter server.
Enables the VMware VI SDK.
Displays SVS connection information.
Connects to remote machines.
Creates a VMware virtual switch.
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
svs connection
1219