Cisco Nexus 5500 Series Command Reference Manual page 23

Chapter C Commands
•
•
•
•
•
If interfaces are configured for the EtherChannel interface and a member port is removed from the
EtherChannel, the configuration of the EtherChannel interface is not propagated to the member ports.
Any configuration changes that you make in any of the compatibility parameters to the EtherChannel
interface are propagated to all interfaces within the same channel group as the EtherChannel (for
example, configuration changes are also propagated to the physical interfaces that are not part of the
EtherChannel but are part of the channel group).
Examples
This example shows how to add an interface to LACP channel group 5 in active mode:
switch(config)# interface ethernet 1/1
switch(config-if)# channel-group 5 mode active
switch(config-if)#
This example shows how to forcefully add an interface to the channel group 5:
switch(config)# interface ethernet 1/1
switch(config-if)# channel-group 5 force
switch(config-if)#
Related Commands Command
show interface
port-channel
show lacp
show port-channel
summary
OL-27880-02
LACP port priority
Debounce
Rate mode
Shutdown
SNMP trap
Description
Displays information about the traffic on the specified EtherChannel
interface.
Displays LACP information.
Displays information on the EtherChannels.
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
channel-group (Ethernet)
117