Cisco Nexus 5500 Series Command Reference Manual page 315

Chapter Show Commands
show interface vethernet
To display information about a virtual Ethernet (vEth) interface configuration, use the show interface
vethernet command.
Syntax Description veth-id
brief
description
detail
mac-address
status
switchport
trunk
Command Default
None
Command Modes EXEC mode
Command History Release
5.2(1)N1(1)
Examples
This example shows how to display the configuration information of a specified virtual Ethernet
interface:
switch# show interface vethernet 1
Vethernet1 is down (nonParticipating)
300 seconds input rate 0 bits/sec, 0 packets/sec
300 seconds output rate 0 bits/sec, 0 packets/sec
Rx
Tx
OL-27880-02
show interface vethernet veth-id [brief | description | detail | mac-address | status | switchport
| trunk]
Virtual Ethernet interface number. The range is from 1 to 1,048,575.
(Optional) Displays brief information about the vEth interface.
(Optional) Displays the vEth interface description.
(Optional) Displays detailed configuration information about the vEth
interface.
(Optional) Displays the MAC address of the vEth interface.
(Optional) Displays the vEth interface line status.
(Optional) Displays the vEth interface switchport information.
(Optional) Displays the vEth interface trunk information.
Modification
This command was introduced.
Bound Interface is --
Hardware is Virtual, address is 0005.9b74.a6c0
Port mode is access
Speed is auto-speed
Duplex mode is auto
0 unicast packets 0 multicast packets
0 input packets 0 bytes
0 input packet drops
0 unicast packets 0 multicast packets
0 output packets 0 bytes
0 flood packets
0 output packet drops
0 broadcast packets
0 broadcast packets
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
show interface vethernet
1309